In nearly all situations, most people spend quite a lot of money buying their lift truck. Hence, it is very important to take good care of it in order to protect your investment well into the long run. It is really a great idea to know the procedures that are carried out in taking care of and maintaining this equipment.
By starting up the forklift and listening closely how it works is among the best ways to tell how good the engine is running. Like for instance, if there are any knocks or misses, the machinery is defective and this must raise several issues. In addition listen carefully for any squealing sounds that come from the belts because these sounds would provide you with a lot of information.
Some of the main components requiring attention during maintenance include the horn, safety warning devices, gauges, the lights and the overhead guard. Any faulty components or burnt out light bulbs need to be replaced as soon as they are noticed. It is also essential to check the wiring.
The battery compartment terminals should be cleaned when the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Every battery cell must be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be replaced regularly. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker to be able to keep track.
After the oil change is carried out and the filters have been replaced, a visual inspection of the drive axle needs to be carried out. If there is a grease fitting on the axle make certain to apply some grease. Check the engine belts for any cracks or frays. If you find any, fix the issue accordingly. Afterwards, inspect each and every other component of the equipment like the wheels. If any type of problem or fault is detected, be sure to address it immediately in order to make sure the machinery is working at its safest and optimum levels.