It is vital to use extra care when using a rough terrain scissor lift. Operators should be completely aware of the surrounding environment. Long booms on the machines act as levers from the center of the drive unit. For instance, a 6 inch bump can lead to a 3 foot bounce when the operator is at the driver controls. Take into consideration all other traffic nearby, since they might not be aware that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface that has no mud or water. These areas cover deep potholes which could be probably cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, completely extended. Be sure to just use wooden chalk blocks that are approved.
Several lifts would operate from the end of the boom on a metal platform. Long booms act levers on the drive unit. While you are at the driver controls, a 6-inch bump could result in a 3-foot bounce. Be aware of all other traffic. They may not know that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas could conceal deep potholes wherein the lift tires can fall, tipping the occupants. Extend all outriggers, if provided, completely. Place just approved wooden chalk blocks underneath the outrigger pads in order to prevent the unit from moving.
Overhead power lines are a serious hazard for lift drivers no matter what lift is being utilized. Like for example, if the platform driver is not being aware, or if the platform is being controlled by personnel on the ground that is not able to correctly access proximity to wiring and thus, either the platform itself or the worker can be easily brought into contact with electrical wires. The worker could be electrocuted unfortunately unless properly insulated.